Deflection instrument uses: The instrument is mainly used to detect the shaft, the radial disc type work and end a round circle beat beat, the new product design, elegant appearance, high precision, easy operation, etc., can greatly enhance the use of this instrument efficiency and accuracy. 
 Deflection apparatus main technical parameters: 
 1, No. 2 Morse taper face of the top 60 ° radial Morse taper round beating ≤ 0.005mm 
 2, the top axis in the 100mm range on parallel rails (horizontal and vertical directions) ≤ 0.006mm 
 3, the part is the maximum diameter of 270mm-400mm 
 4, measuring the length of 300mm, 500mm, 1000mm, 1500mm 


 Gear beating tester uses: Gear radial △ Fr, a turn in the gear within the probe in the slot or on the gear teeth, and tooth high school two-sided contact, the probe relative to the amount of gear axis of the launch. To this end, the ring gear runout check is shaped by the measurement with the original rack when the first line, shown below, for use in such a schematic representation of the tester. Inspection, will be installed in the shaft on the gear being inspected, as set in the instrument thimble between the two, the rack tooth profile with the original probe, inserted into the gear teeth in order, and show by direct measurement of head position on the gear runout of the axis of rotation. 
 [Help] 6 or 6 to check the accuracy below the rank of cylindrical, conical teeth outside the worm gear and the co-radial or face runout. 
 Measured the maximum diameter of gear pitch gear 
 0.3-2mm 1-6mm 150mm 300mm 
 Turn the tables indicate the scope of testing planes division value 
 ± 0 ° 0.001mm 
 Apparatus to demonstrate the value of changes in the measurement process 10 times, less than the following: 
 Smooth surface measurements: measuring gear: 
 ▲ ▲ without a lever without a lever with a lever ▲ 
 1um 2um 3um